Elo TouchSystems JH 10T08 Uživatelský manuál stáhnout pdf (Strana 18)

INB100014-1 (Rev 19)

IND100078-10

General Installation Recommendations

Installation

- The impairment of read-out from a display screen by direct light from lamps or the sun must be

avoided. Rear windows must be blacked out by means of roller blinds or Venetian blinds.

- Disturbing reections on the screen of a display caused by pilot lamps and illuminated signs must

be prevented by suitable measures (screening or relocating).

- When a product is being installed, the surface base or bulkhead must be checked to ensure that it

is at in order to avoid twisting of the unit when the xing screws are tightened, because such

twisting would impair mechanical functions. Any unevenness should be compensated for by

means of spacing-washers.

- The grounding screws of the units must be connected to the body of the ship (ground); the wire

used should have a cross sectional area of at least 6 mm

- Transportation damage, even if apparently insignicant at rst glance, must immediately be

examined and be reported to the freight carrier. The moment of setting-to-work of the equipment

is too late, not only for reporting the damage but also for the supply of replacements.

Cables

Use only high quality shielded signal cables. For RGB/DVI cables use only cables with separate

coax for Red, Green and Blue. Jakob Hatteland Display can supply a varity of high quality RGB/

DVI, RS232, PARALLEL, LAN and USB cables intended for this use.

Cable Entries & Connectors (Marked area) - Illustration only

Bottom View

Back View

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

Žádné komentáře

Elo TouchSystems JH 10T08 Uživatelský manuál Strana 18