Elo TouchSystems B-Series Uživatelská příručka stáhnout pdf (Strana 124)

Section 4. USB Communications

TERMINATION_CHAR PROPERTY

Property ID: 5

Property Type: Byte

Length: 1 byte

Get Property: Yes

Set Property: Yes

Default Value: 0D (hex) (carriage return)

Description: This property is defined as follows:

mod c c c c c c c

mod 0 – Send c after card data

1 – Send c after each track

c 1-127 – 7 bit ASCII char code

0 – send nothing

This property is stored in non-volatile EEPROM memory so it will not change when the unit is

power cycled. When this property is changed, the unit must be power cycled to have these

changes take effect. If a value other than the default value is desired, it can be set by the factory

upon request.

SS_TK2_7BITS PROPERTY

Property ID: 6

Property Type: Byte

Length: 1 byte

Get Property: Yes

Set Property: Yes

Default Value: 40 (hex) ‘@’

Description: This character is sent as the track 2 start sentinel for cards that have track 2

encoded in 7 bits per character format. If the value is 0 no character is sent. If

the value is in the range 1 – 127 then the equivalent ASCII character will be

sent.

This property is stored in non-volatile EEPROM memory so it will not change when the unit is

power cycled. When this property is changed, the unit must be power cycled to have these

changes take effect. If a value other than the default value is desired, it can be set by the factory

upon request.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 164 165

Žádné komentáře

Elo TouchSystems B-Series Uživatelská příručka Strana 124